CCNP Wireless CUWSS 642-732 Summary Notes 16 : Layer 2 Active Site Survey using AirMagnet Survey Pro

AirMagnet Survey Layer 2 site survey can be performed with AirMagnet Survey PRO to determine the access point placement and coverage. AirMagnet Survey PRO has the capability of doing pre-site surveys (before the install) and post-site surveys (after the install), also known as an audit, to ensure adequate coverage. In the configuration menu: Select the SSID Set the Tx … Continue reading CCNP Wireless CUWSS 642-732 Summary Notes 16 : Layer 2 Active Site Survey using AirMagnet Survey Pro

CCNP Wireless CUWSS 642-732 Summary Notes 7 : Survey Models

Data Only Coverage Does not require a large amount of overlap due to rate shifting; generally 5 to 10 percent, with 10 - 15  % overlap between the cells Separation of access points is typically 120 to 130 feet ( 37 to 40 m) 2.4 band 802.11b/g propagates through floors. The 5-GHz waveform of 802.11a has approximately … Continue reading CCNP Wireless CUWSS 642-732 Summary Notes 7 : Survey Models

CCDA 640-864 Summary Notes – Chapter 5 – Day 11

Exam Topic 2 - Part 2: Cisco Unified Wireless Network (UWN) Architecture LWAPP Discovery of WLC LWAPP Image procedure: CAPWAP Image procedure: CAPWAP AP sends a CAPWAP discovery request WLC responds withCAPWAP response within 60 seconds WLC selection is configurable onWLC. AP selects according to the following order Primary sysName (preconfigured) Second sysName (preconfigured) Tertiary sysName … Continue reading CCDA 640-864 Summary Notes – Chapter 5 – Day 11

Cisco R&S: Attributes used by BGP in route selection

Nexthop - Should be accessible, otherwise, drop. Largest Weight. Not part of the routing update. Largest Local Preference. Prefered path to a remote destination. Part of the routing update. Default is 100. Local to the AS. Originated by BGP running on this computer. Shortest AS-PATH. Lowest origin type. IGP < EGP < Incomplete Lowest MED … Continue reading Cisco R&S: Attributes used by BGP in route selection